Declaration of Horizontal Property Section 5

JRCAI Home Page | Board of Directors | Financial Reports | By-Laws | Declaration of Horizontal Property | Meeting Minutes | F A Q | Policies | Rental  Pool | What’s New...

5. Description of Unit

 

(a) Appurtenances. Each Unit shall consist of all space within the boundaries of such Unit as hereinafter defined and all portions of the Building situated within such boundaries, all as shown on the Plans, including but not limited to all furnishings, fixtures, facilities, furnaces, equipment, appliances, air conditioning units, ducts and piping connected to furnaces and air conditioning used solely and exclusively by the Unit even though the same are located outside the boundaries of the Unit and in some cases are located outside the Buildings, but not including any such portions of any of the Buildings designated for use, benefit, support, safety or enjoyment of any other Unit or Common Areas or which may be necessary for the safety, support, maintenance, us, and operation of any of the Buildings or which are Common Areas as defined by applicable law or this Declaration.

(b) Boundaries. The boundaries of each Unit shall be as shown on the Plans measured between the interior unfinished surface of the floors, ceilings and interior walls of each Unit. In the event any horizontal or vertical boundary line as shown on the Plans does not coincide with the actual location of the respective wall, floor or ceiling surface of the Unit because of inexactness of construction, settling after construction, or for any other reasons, the boundary lines of each Unit shall be deemed to be and treated for purposes of occupancy, possession, maintenance, decoration, use and enjoyment, as in accordance with the actual existing construction. In such case, permanent easements for exclusive use shall exist in favor of the Owner of each Unit in and to such space lying outside of the actual boundary line of the Unit, but within the appropriate wall, floor or ceiling surfaces of the Unit. Minor deviations in measurements between the Plans and actual construction will not affect title to Units.